Mitel 3000
Installation & Maintenance Manual
67
NOTE: The option to program Telesecretary is presented when a T1/E1 PRI Module is installed. This option is
not presented if the switch is equipped with CO Lines only.
“Extensions” programming options.
Feature Default Notes
Name Programming Not programmed See page 85.
Restriction Classes
• Day Class-Of-Service
• Night Class-Of-Service
All extensions in Class 1. See page
85.
Tone Protect All extensions protected See page 86.
Page Protection All extensions not
protected
See page 86.
Open Door Restriction No restrictions See page 86.
Individual Caller ID List Not programmed See page 86.
Sys. Speed Dial Override All extensions off See page 86.
Voice Mail Boxes
• Standard Voice Boxes
• Information Only VB
All extensions off See page
87.
Extension Disconnect All extensions connected See page 87.
VM Capacity % Used Not applicable See page 82.
No Call Logging All extensions off See page 74.
External Forwarding
• No Trunk-to-Trunk calls
• All Calls
• External Calls Only
All Calls See page
88.
Examine Passwords
• Ext. Lock Password
• Voice Mail Password
• System Voice Mail Box
123
1111
1111
See page
88.
Restrict Use Of PA No restrictions See page 89.
Port Swapping Not programmed See page 89.
Hot Line Not programmed See page 89.
Manager/Assistant Not programmed See page 89.
Tele-Secretary (See Note Below) Not programmed See page 91
20 Hz Ringing All extensions off See page 91.
Reverse Cadence All extensions on See page 91.
Keypad Confirmation All extensions on See page 91.
Flexible Numbering Not programmed See page 93.
DSS Extensions Extensions 20 –27 on; all
others extensions off
See page 95.
Call Recording All extensions off See page 95.
Send Specific DID (T1/E1 PRI Card only). All extensions on See page 92
Remote Notification Off See page 79
Barge-In
• Barge-In Extensions
• Barge-In Protection
• Barge-In Tone
No extensions
programmed
No extensions protected
Tone On
See page
95.
Paired Extensions
• Master Extension
No extensions paired
See page
96.