Mitel 3000 - Adding Host Validator; Host IP, Subnet Mask, and Direction Entry

Mitel 3000
Installation & Maintenance Manual
68
• Alternate extension
NOTE: The Telesecretary option is presented when a T1 / PRI module is installed. It is not shown if the
system is equipped with CO Lines only.
Lines Settings Options
If “Lines” is selected, the following screens appear:
1. 2.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
3. 4.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
Select option
- CID Programming
- PSTN Programming
- Exit
If “Lines” is selected and T1/E1 PRI is programmed, the following screens appear:
1. 2.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
3. 4.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
Select option
- PRI Programming
- Call Routing Priority
- T1 (RBS) or PRI (ISDN)
5. 6.
Select option
- T1 Channels
- System Voice Mail Box
- CID/ANI Table
Select option
- DID/DNS Table
- Exit
If “Lines” is selected and E1 PRI is programmed, the following screens appear:
1. 2.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
3. 4.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
Select option
- CID Programming
- DID Programming
- Accept on Busy
5. 6.
Select option Select option