Mitel 3000 - Security Trigger Configuration; Defining Security Triggers

Mitel 3000
Installation & Maintenance Manual
70
“Lines” programming options.
Feature Default Notes
Equipped Lines All Lines equipped See page 97.
Group Programming
• Ring Group
• Hunt Group
Groups 1 with first 8 extensions,
groups 2 - 20 with extension 20
only
See page 98.
Incoming Ringing Group 1 for all Lines and
Accesses
See page 99.
Outgoing Restriction No restrictions See page 99.
Incoming Calls Only No restrictions See page 99.
Outgoing Groups
• Lines in Groups
• Linear or Distributed
line selection
All Lines in group 1
Linear Hunting selected
See page
101.
PBX Group Not programmed See page 102.
LCR Codes
• LCR on
• LCR off
None programmed See page
102.
LCR Timebands
• LCR On Time
• LCR Off Time
• LCR Weekend
Not Programmed See page
102.
PSTN Programming
• Tone Dialing
• Loop calling
• Caller ID Detection
• Dial tone detection
• Long CO Line
• Line Name
See page
104.
See page
104.
See page
105.
See page
105.
See page
106.
PRI Programming Not Programmed See page 108.
Call Routing Priority Not programmed See page 108.
T1 (RBS) or PRI (ISDN) Not programmed See page 109.
T1 Channels Not programmed See page 109.
System Voice Mail Box Not programmed See page 106.
CID / ANI Table Not programmed See page 114.
DID / DNIS Table Not Programmed See page 114.
CID Programming (CID /ANI
Table when T1 / PRI module
is installed)
Not programmed See page
113.