Mounting the phone on the wall
1. Place the supplied drilling template for wall mounting on the wall position you want and mark the
positions for the mounting screws. Depending on the type of wall, you may need some dowel plugs.
Screws and dowel plugs are part of the delivery.
2. Put the telephone with the mounting openings over the heads of the wall screws and pull the phone
downwards to stop it.
3. On the cradle is a small clamp which is flush with the cradle surface. Push it up with a small flat head
screwdriver and remove it from the phone.
4. With the cleat arm towards you and the flat side of the clamp towards the phone turn the clamp 180°
and push it again into the cut-out in the phone cradle. Press in the clamp till it is flush with the surface
and only the feet of the clamp are protruding.
Configuring keys
Configure the keys on analogue phones Mitel 6700 Analogue in the WebAdmin terminal configuration.
The phone must be connected during configuration so the key configuration can be stored on the phone
immediately. If not, you can load the key configuration on the phone after connecting the phone, by clicking
Update key configuration on phone.
To load the key configuration on all connected Mitel 6700 Analogue series phones, click Update key
configuration for all Mitel 6700 Analogue phones.
To load the key configuration stored in the WebAdmin from the connected phone, dial the function code
*#53.
Labelling the phone
1. Remove the cover with the logo on top of the control panel by pressing down slightly and pushing up.
2. Pull out the designation label on the lugs, label it then push it back again into the cut-out.
3. Carefully put back the cover with the logo, so that the paper lugs are covered.
Powering the phone
The phone is powered via the FXS line.
To Next Page
Loading...
Need help?
General
