Configuration
5.5.2.3.4 Lost password
If another user has also been defined with the User access control administration right released, he can
simply overwrite with a new password the password lost by another user. The next time he logs in, the
corresponding user is prompted to change the password and enter the new one he has been assigned.
Note:
For security reasons, there is no password-free access for the SMB Controller. Be careful with your
passwords.
5.5.3 Automatic exit from the configuration
Access to the configuration is interrupted if no changes are made to a parameter value or the navigation
system is not used during a specific timeout.
This is valid for both configuration tools, the SMB Controller Manager as well as for WebAdmin.
5.5.4 WebAdmin access log
An access log with 20 entries is drawn up for each user account so that the history of accesses to the
configuration can be tracked. Denied access attempts using erroneous or incorrectly type passwords
are also logged. The logs can be read by each user (authorization level) Administrator in Expert mode
required).
Retrieving the log data
The system monitors all the accesses and failed access attempts and saves them in the file system of the
communication server. These lists can be retrieved locally or remotely.
CLIP verification
If in the general maintenance settings of the parameter CLIP required is activated, remote maintenance is
only possible if the retrieving party is using a CLIP. The CLIP number is also recorded by the access log.
Entering the processes in the log
Each access attempt generates an entry in the corresponding list.
In case of remote maintenance an entry will not be generated if remote maintenance is barred or if CLIP
required is activated in the configuration and no CLIP is received.
Release 7.1
183 System Manual for Mitel SMB Controller
To Next Page
Loading...
Need help?
General
