Operation and Maintenance
6. Only for Mitel 620 DECT, Mitel 630 DECT with black card holder:
Take the protective cover provided with the card and put it on top of the card holder (see microSD card
rightwards).
Note:
The protective cover should not be used for Mitel 620 DECT, Mitel 630 DECT with a white card
holder or in Mitel 622 DECT, Mitel 632 DECT and Mitel 650 DECT.
7. Insert the battery and cover the battery compartment.
Figure 70: microSD card
Behaviour after inserting a new microSD card
After starting the cordless phone you will receive, in the start phase, a message informing you that a new
card has been detected. The two typical cases are described below:
Cordless phone has not yet been registered:
Accept the new card.
• The local settings are copied to the card.
Register the phone on the communication server.
• The registration data is stored on the card.
• Modifications on the local settings are henceforth also stored on the card.
Cordless phone is already registered:
Accept the new card.
• The local settings are copied to the card.
• The registration data is copied to the card and erased from the cordless phone memory.
• Modifications on the local settings are henceforth also stored on the card.
Release 7.1
211 System Manual for Mitel SMB Controller
To Next Page
Loading...
Need help?
General
