Product and Safety Information
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the
user to the presence of uninsulated dangerous
voltage within the product’s enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
product
Indicates ESD components. Failure to observe
information identified in this way can lead to
damage caused by electrostatic discharge.
The ground symbol within a circle identifies the
product to be connected to an external conductor.
Connect this product to earth ground before you
make any other connections to the equipment.
Operating safety
MiVoice Office 400 communication servers are operated on 115/230 VAC mains power. Communication
servers and all their components (e.g. telephones) will not operate when mains power fails. Interruptions
in the power supply will cause the entire system to restart. A UPS system has to be connected up-circuit to
ensure an uninterruptible power source.
When the communication server is started for the first time, all the configuration data is reset. You are
advised to backup your configuration data on a regular basis as well as before and after any changes.
Installation and operating instructions
Before you begin with the installation of the MiVoice Office 400 communication server:
• Check that the delivery is complete and undamaged. Notify your supplier immediately of any defects; do
not install or put into operation any components that may be defective.
• Check that you have all the relevant user documents at your disposal.
• Configure this product with only the assemblies specified and in the locations stated in the user
documentation.
• During the installation follow the installation instructions for your MiVoice Office 400 product in the
sequence that is given and observe to the safety warnings they contain.
Release 7.1
3 System Manual for Mitel SMB Controller
To Next Page
Loading...
Need help?
General
