햵
Pick and assign the variables to the two STAR_DELTA Function Blocks on the
MOTOR_CONTROL Program POU as shown:
Save the project and
Rebuild All
to compile the code:
Download and monitor the project. Before the Function Blocks can operate, it is necessary to
write values into the TIMEBASE inputs: STAR_DELTA1.TB and STAR_DELTA2.TB. This is
carried out by using the online variable modification technique described in an earlier section.
Simulate the operation of both Function Blocks as shown on the next page in order to confirm
that everything functions as expected:
Data Unit Types (DUT) Assigning DUT Variables to Function Blocks
Training Manual GX IEC Developer 10 - 9
To Next Page
Loading...
