햵
Define the head address of the master module.
햶
Configure the slave station. In this example it is a head module of the MELSEC ST series
(ST1H-PB).
PROFIBUS/DP Communication Configuring the PROFIBUS/DP Network
Training Manual GX IEC Developer 17 - 3
Enter the head address of the
PROFIBUS/DP master module in this field.
In this example the module is the 2nd
special function module.
Therefore it has the adress "1".
First select the PROFIBUS
address of the slave station
Then select the mounted modules
of the ST system (see next page).
To Next Page
Loading...
