햶
In the Ethernet Module settings, click on
Transfer Setup
and take over the settings
shown below in the red frame.
햷
Click on
Write
in the Ethernet Module settings. As you see, the transfer speed for COM1
is set to 115.2 Kbps.
In the dialogue window Write to Ethernet Module click on
Write
and transfer your settings
to the PLC. Confirm displayed messages with
YES
resp.
OK
.
Ethernet Communications Configuring the FX3U-ENET by FX Configurator-EN
Training Manual GX IEC Developer 18 - 5
To Next Page
Loading...
