12-18
Removal sequence
1 Drain plug
2 Oil filter
3 Engine oil bypass alarm switch
4 O-ring
5 Oil filter head
6 Gasket
: Non-reusable parts
Installation sequence
Follow the removal sequence in reverse.
WARNING
• Wipe up any spilled engine oil, as it can cause fires.
• To avoid any risk of burns, take care not to touch the engine oil when the engine is hot.
CAUTION
• When adding engine oil, be careful not to allow engine oil to smear the V-belt. A V-belt smeared with oil
will slip, resulting in reduced cooling efficiency.
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Mark Parts to be tightened Tightening torque Remarks
Drain plug 7.8 ± 2 {0.8 ± 0.2} –
Engine oil bypass alarm switch 49 ± 4.9 {5.0 ± 0.5} –
Bolt (Oil filter head mounting) 37 to 53 {3.6 to 5.4} –
Mark Points of application Specified lubricant and/or sealant Quantity
Oil filter gasket
Engine oil As required
O-ring
OIL FILTER
To Next Page
Loading...
