14-32
Disassembly sequence
1 Thermostat cover
2 Gasket
3 Thermostat
4 Water temperature sensor
5 Plug
6 Cock
7 Thermostat case
8 Gasket
9 O-ring
10 Joint
11 O-ring
: Non-reusable parts
CAUTION
• Do not remove the thermostat case
unless it has a water leak or any
other defect.
Assembly sequence
Follow the disassembly sequence in re-
verse.
Service standards (Unit: mm)
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Location Maintenance item Standard value Limit Remedy
3 Thermostat
Valve opening
temperature
76.5 ± 2°C–
Replace
Valve lift/temperature 10 or more/90°C–
Mark Parts to be tightened Tightening torque Remarks
Water temperature sensor 35 ± 7 {3.6 ± 0.7} –
Cock 20 to 26 {2.0 to 2.7} –
Mark Points of application Specified lubricant and/or sealant Quantity
O-ring Soapy water As required
Thread of plug Loctite 575 As required
THERMOSTAT
To Next Page
Loading...
