15-8
Removal sequence
Installation sequence
Follow the removal sequence in reverse.
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Mark Parts to be tightened Tightening torque Remarks
Clamp (rubber hose mounting) 4.9 {0.5} –
Eyebolt (oil feed pipe mounting) 21 {2.1} –
Nut (exhaust pipe mounting)
41 {4.2} –
Nut (turbocharger mounting)
Mark Points of application Specified lubricant and/or sealant Quantity
Turbocharger (to be filled with engine oil) Engine oil As required
1 Air inlet pipe
2 Rubber hose
3 Eyebolt
4 Oil feed pipe
5 Oil return pipe
6 Gasket
7 Turbocharger cover
8 Exhaust pipe
9 Gasket
10 Turbocharger
(See later section.)
11 Gasket
*
a: Exhaust manifold
: Non-reusable parts
TURBOCHARGER
To Next Page
Loading...
