11
11-55
Assembly sequence
Follow the disassembly sequence in reverse.
Service standards
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Location Maintenance item Standard value Limit Remedy
4
Flywheel
<Type A, Type B>
Friction surface distortion 0.05 or less 0.2
Correct or
replace
Friction surface height
Type A 21 20
Replace
Type B 44.5 43.5
Friction surface runout
(when fitted)
– 0.2
Correct or
replace
21
Eccentricity of flywheel housing measured at spigot
joint section (when fitted)
– 0.2
Inspect or
replace
Mark Parts to be tightened Tightening torque Remarks
Bolt (flywheel mounting) 98 {10} + 150°
• Wet
• Can be reused
up to 3 times
Plug 88 {9} –
Eyebolt (air outlet pipe mounting) 98 {10} –
Bolt (air suction pipe mounting) 19 to 28 {1.9 to 2.8} –
Eyebolt (water inlet pipe mounting)
50 {5.0} –
Eyebolt (water outlet pipe mounting)
Eyebolt (oil pipe mounting) 21 {2.1} –
Mark Points of application Specified lubricant and/or sealant Quantity
Thread of bolts
Engine oil As requiredO-ring
Rear oil seal lip
Rear oil seal surface to be mated with flywheel housing
ThreeBond 1207C As required
Engine mounting surface of flywheel housing
+10°
0
To Next Page
Loading...
