Mitutoyo EJ-102N - Page 49

35
No. 99MBC139A
3 Operation Procedure
No. Set value
Per-
axis
setting
Set value: Operation
Default
value
Description
08
Tolerance
judgment
setting
N/A
0: 3-step tolerance judg-
ment
1: 5-step tolerance judg-
ment
2: No tolerance judgment
0
Selects whether or not the tolerance
judgment function is used.
When the tolerance judgment is
used, selects the number of steps of
tolerance judgment.
Tips
Changing the settings does not clear
tolerance values S1 to S4, which are
maintained. However, the following
adjustments may be made in the
event that the following inconsisten-
cies occur.
When the setting is changed from
"3-step tolerance" or "No tolerance" to
"5-step tolerance":
When S2 < S1 or S4 < S2, S2 is
replaced with the value of S1.
When S3 < S1 or S4 < S3, S3 is
replaced with the value of S4.
09
Display at
startup
N/A
0: Counter stand-by
1: Counter displayed
0
Selects whether to display the
standby state or the counter display
at startup.
If you want to prevent counter error,
set 1.
Tips
For details about screen display in the
counter stand-by state, see "3.1
Power ON/OFF" on page 21.
10
ERR/ALLGO
selection
(I/O input/out-
put setting)
N/A
0: Used as ERR
1: Used as ALLGO
0
Selects whether to use the ERR or
ALLGO signal as the external output
function.
Tips
When multiple EJ Counters are linked
together, all of them must have the
same setting. Correct output will not
be obtained if any of the EJ Counters
hasadi󰀨erentsetting.
11
Channel
coupling
selection
(I/O input/out-
put setting)
N/A
0: Do not couple chan-
nels
1: Couple channels
0
Selects whether to couple the 1 or 2
SEL external input signal to the EJ
Counter's display channel.
Tips
The [SEL/CE] key also works to cou-
ple the signal.