NOTE
• Adjust the inclination angle assuming that the angle is determined depending on the
direction in which the X-axis unit rotates counterclockwise.
CAUTION
• If the drive unit is to be tilted, there is a risk of having your finger caught between the
Z1-axis detector unit and the X-axis drive unit inclination wheel. Carefully rotate the
wheel.
• If the drive unit is to be tilted, there is a risk of damage in the Z1-axis detector unit due
to bump against the base.
• Carefu-lly tilt the drive unit so as not to bump it against the base.
• If the drive unit is to be lowered while being tilted, there is a risk of damage in the
Z1-axis detector unit due to bump against the base before stopping at the limit of the
safety device. Carefully lowered the drive unit so as not to bump it against the base.
• The inclination angle of the X axis is not related to the part program. Before running
the part program, adjust the inclination angle to the inclination angle when the part
program was created.
No. 99MBB187A
1-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
