Monarch SE 2004-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Section 4 Appliances | 187
NOTE: Allow at least 5 minutes for light bulbs to cool off before
touching bulbs to avoid accidental burning of the skin.
To Open the Light Bulb Area:
• Remove the rim by pulling straight forward.
• Hold glass in place while removing retaining top clip.
• Lift glass out and store in a safe place.
CAUTION: Even though the glass is safety glass it may break if
bumped, struck or dropped. Care must be taken when handling
the glass.
Helpful Hints:
It is a good idea to replace all light bulbs at one time if they are close to the end
of their rated life. Group replacement will reduce the number of times needed to
open the unit to replace light bulbs.
To Replace the Bottom Light Bulbs Which Generate the Flames and
Embers:
Bulb requirements: Quantity of 4 clear chandelier or candelabra bulbs with an
E-12 (small) socket base, 60 watt rating. Example GE 60BC or Phillips 60 CTC.
Do NOT exceed 60 watts per bulb.
• Lift up front edge of log until it clears the front tabs. Pull out until the
rear tab clears the back ledge, then lift out.
• Examine the bulbs to determine which bulbs require
replacement.
• Hold the socket while unscrewing the bulb.
• Hold the socket while screwing in the new bulb.
• Replace the log by pushing it down and in until it rests against the
mirror.
To Replace the Top Bulbs Which Illuminate the Log Exterior:
Bulb requirements: Quantity of 2 clear chandelier or candelabra bulbs with an
E-12 (small) screw base. Please refer to the label adjacent to the upper lights for
the correct wattage for your model. Do NOT exceed 15 watts per bulb.
• Examine the bulbs to determine if they need replacing.
• Hold the socket while unscrewing the bulb.
• Hold the socket while screwing in the new bulb.
To Reassemble Light Bulb Area:
• Replace the glass and hold it in place at top.
• Fasten retaining clip to hold glass in place.
To Next Page
Loading...