230 | Section 5 Equipment -------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- ----------------- Monarch SE 2004
• AUDIO SETTING MEMORIES (P1/P2/P3) - Three pre-set but-
tons are provided on this unit to store desired audio level positions
into memory and easily recalled. To set any of the three audio memory
use the following procedure:
1. Use the Select button and Level control to adjust the setting of the
volume, treble, bass, balance and fader to the desired positions.
2. Press the SELECT button to call any of the audio functions on the
display. Within two seconds of pressing the Select button, and while
the audio function is still on the display panel, press the PRE-SET
button (1 through 3) to be set and continue to hold it in. After
approximately two seconds the pre-set number (“P-1”, “P-2”, or “P-
3) will appear on the display panel indicating that the audio levels are
now set into that memory position. The settings can be recalled at any
time by pressing the SELECT button and then that PRE-SET button
within two seconds.
• AUDIO MUTE (MUTE) - This button is used to mute the volume
from the system. By pressing the button the indication “MUTE” will
appear on the display panel and the volume will be muted. Pressing
the MUTE button again will return the volume level to the setting in
use before the Mute function was activated.
• AM/FM BAND SELECTOR (BAND) - During radio operation each
momentary press of this button will change the radio band. The
indication “AM1”, “AM2”, “FM2” or “FM3” will appear on the
display panel according to your selection.
• MANUAL UP/DOWN TUNING & AUTOMATIC SEEK
TUNING (TUN) - Each time the RIGHT ARROW button is tapped,
the radio will tune one frequency step higher. Similarly, each tap of
the LEFT ARROW button will tune one frequency step lower. To
manually tune in a station tap the button of the appropriate direction until
the desired frequency is reached. Pressing either button for longer than
0.5 seconds and then releasing will activate the Automatic Seek
Tuning function. The radio will seek the next available station and
stop at the frequency. The Seek function can be stopped by pressing
the button again or activating any other tuning function.
To Next Page
Loading...