Monarch SE 2004--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Section 5 Equipment | 231
• AUTO-STORE TUNING (AS) & PRE-SET SCAN TUNING (PS) -
During radio operation press this button momentarily to scan the six
stations pre-set into the memory of that band. The unit will stop at
each pre-set station for five seconds before continuing to the next
pre-set station. Press the button again momentarily to stop Pre-Set
Scan operation and remain on the selected frequency. Pressing the
button for longer than two seconds will activate the Auto-Store Tuning
feature which will automatically scan the band and enter up to 6
strong stations into the six pre-set memories.
• STATION PRE-SET MEMORIES - To set any of the six pre-set
memories in each band use the following procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the Manual Up/Down or
Automatic Seek Tuning controls.
3. Press the pre-set button to be set and continue to hold it in. After
approximately two seconds the pre-set number will appear on the
display panel indicating that the station is now set into that pre-set
memory position. The station can now be recalled at any time by
pressing that button.
4. Repeat the above procedure for the remaining five pre-sets on that
band and for the other four bands on the unit.
• DISC SLOT - With the label surface facing up, gently insert the disc
into the slot until the soft-loading mechanism engages and disc play
begins.
• TRACK SELECT (TRK) - These buttons are used to quickly select
the beginning of a particular track. With each momentary tap of the
Forward Track Select button (right arrows) the next higher track
number will be selected as shown on the display panel. Similarly, with
each momentary tap the Backward Track Select button (left arrows)
the next lower track number will be selected.
• CD PLAY/PAUSE DESELECTOR (II) - During disc play, press this
button to temporarily stop play of the disc. Press the button again to
resume play of the disc from the point at which it was stopped.
• REPEAT PLAY SELECTOR (RPT) - During disc play, press this
button to repeat the play of the selected track (“RPT” will appear on
the display panel). Play of the track will continue to repeat until the
button is pressed again.
To Next Page
Loading...