Preparing Your Radio for Use
English
5
Attaching the Universal Connector Cover
The universal connector is located on the antenna side of the
radio. It is used to connect accessories to the radio.
Note: To prevent damage to the connector, shield it with the
connector cover when not in use.
Insert the hooked end of the
cover into the slot above the
connector. Press downward on
the cover’s top to seat it in the
slot.
Rub the ball of your thumb from
the top to the bottom of the cover
while applying pressure towards
the radio. This should flex the
cover and snap it into place.
To remove the universal
connector cover, insert a flat-
bladed screwdriver into the area
between the bottom of the cover
and the slot below the connector.
Hold the top of the cover with
your thumb while you pry the
bottom of the cover away from
the radio with the screwdriver.
Turning On the Radio
Rotate the On/Off/
Volume Control
Knob clockwise until
you hear a click.
If the power-up test is
successful, you see
SELF TEST on the
radio’s display
momentarily, followed
by the home display.
Note: If the power-up test is unsuccessful, you see Error
XX/YY (XX/YY is an alphanumeric code).
Note: Turn off the radio, check the battery, and turn the radio
back on. If the radio fails the power-up test again,
record the Error XX/YY code and contact your dealer.
On
6875945M01-A_Full.book Page 5 Tuesday, July 8, 2008 12:54 AM
To Next Page
Loading...
Need help?
General
