Advanced Features
English
33
Press the Menu Select button directly below Pset to select
the preset preprogrammed talkgroup.
5 If the encryption key slaved to the new talkgroup is erased,
a momentary key fail tone sounds and the display shows
Key fail.
OR
If the encryption key that is slaved to the new talkgroup is
not allowed, a momentary key fail tone sounds and the
display shows Illegal Key.
6 Press H or the PTT button to exit.
OR
Turn the 16-Position Select knob to exit.
Sending a Status Call (ASTRO 25 Trunking Only)
This feature allows you to send data calls to the dispatcher
about a predefined status.
Note: Each status can have up to a 12-character name. A
maximum of eight status conditions is possible.
Procedure:
Press the preprogrammed Status button and proceed to Step 3
of the procedure below.
OR
Follow the procedure below.
1 < or > to Sts.
2 Press the Menu Select button directly below Sts.
3 The display shows the last acknowledged status call, or the
first status in the list.
4 U or D to the required status.
OR
Use the keypad to enter a number corresponding to the
location in the status list.
5 Press the PTT button to send the status.
6 When the dispatcher acknowledges, four tones sound and
the display shows Ack Received. The radio returns to
normal dispatch operation.
OR
If no acknowledgment is received, a low-pitched tone
sounds and the display shows No Acknowldg.
7 Press H to return to the home display.
No traffic is heard on trunked channels while Status Calls is
selected.
If the radio detects no Status Call activity for six seconds, an
alert tone sounds until you press
H or the PTT button.
Using the Dynamic Regrouping Feature (Trunking
Only)
This feature allows the dispatcher to temporarily reassign
selected radios to a single special channel so they can
communicate with each other. This feature is typically used
6875945M01-A_Full.book Page 33 Tuesday, July 8, 2008 12:54 AM
To Next Page
Loading...
Need help?
General
