Advanced Features
English
44
Making a Dynamic Priority Change (Conventional
Scan Only)
While the radio is scanning, the dynamic priority change feature
allows you to temporarily change any channel in a scan list
(except for the priority-one channel) to the priority-two channel.
The replaced (old) priority-two channel then becomes a non-
priority channel. This change remains in effect until scan is
turned off. Scan then reverts to the preprogrammed state.
Procedure:
1 When the radio locks onto the channel designated as the
new priority-two channel, press the preprogrammed
Dynamic Priority button.
2 The radio continues scanning the remaining channels in the
list.
To resume scanning the preprogrammed priority-two channel,
you must leave and re-enter scan operation.
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or noise
(termed a “nuisance” channel), you can temporarily remove the
unwanted channel from the scan list.
This capability does not apply to priority channels or the
designated transmit channel.
Note: Deleting a “nuisance” channel is only possible through
the preprogrammed Nuisance Channel Delete
button. This feature is not accessible through the
menu.
Procedure:
1 When the radio is locked onto the channel to be deleted,
press the preprogrammed Nuisance Delete button.
2 The radio continues scanning the remaining channels in the
list.
Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, do one of the
following:
• Turn the radio off and then turning it on again.
OR
• Stop and restart a scan via the preprogrammed Scan button
or menu.
6875945M01-A_Full.book Page 44 Tuesday, July 8, 2008 12:54 AM
To Next Page
Loading...
Need help?
General
