Advanced Features
English
46
Sending a Call Alert Page
Note: The radio automatically exits the feature, if the time-out
timer is enabled, when the radio is left idle and time is
up. You will hear the Menu Inactive Exit Tone upon
feature exit.
Procedure:
Press the preprogrammed Quick Access (One-Touch) Call
Alert Paging button to send a page to the preprogrammed ID
and proceed to Step 5 of the procedure below.
OR
Follow the procedure below.
1 < or > to Call.
2 Press the Menu Select button directly below Call.
3 U or D to select the alias or ID, and press the PTT button
to initiate the call.
4 If the target radio does not respond after a programmed
period of time, you see Send page? on the display.
5 Press the Menu Select button directly below Yes to send
the call alert page.
OR
Press the Menu Select button directly below No to exit the
screen without sending the call alert page.
6 The display shows Paging <Alias>.
7 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from
your mouth.
8 When you are connected, you see the home display. Press
and hold the PTT button to talk. Release the PTT button to
listen.
OR
If an individual Call Alert page is not acknowledged, the
display shows No Acknowldg.
9 Press the Call Response button to hang up and return to
the home display.
OR
Press H to hang up and return to the home display.
6875945M01-A_Full.book Page 46 Tuesday, July 8, 2008 12:54 AM
To Next Page
Loading...
Need help?
General
