General Radio Operation
English
29
4 Press the Menu Select button directly below Dir to enable
Direct mode. The display shows the Talkaround status icon.
OR
Press the Menu Select button directly below Rptr to enable
Repeater mode.
OR
Press H to exit without changing the current radio setting.
Monitoring Features
Radio users who switch from analog to digital radios often
assume that the lack of static on a digital channel is an
indication that the radio is not working properly. This is not the
case.
Digital technology quiets the transmission by removing the
“noise” from the signal and allowing only the clear voice or data
information to be heard.
Use the Monitor feature to make sure a channel is clear before
transmitting.
Monitoring a Channel
Procedure:
Use the preprogrammed Volume Set Button button.
1 Select the desired zone and channel.
2 Press and hold the Volume Set button to hear the volume
set tone.
3 Adjust the Volume Control knob if necessary.
4 Release the Volume Set button.
5 Press and hold the PTT button to transmit. The LED lights
up solid red.
6 Release the PTT button to receive (listen).
6875945M01-A_Full.book Page 29 Tuesday, July 8, 2008 12:54 AM
To Next Page
Loading...
Need help?
General
