Motorola iDEN Site Controller User Manual

68P80801E30-A 5/1/2002 4-55
Gen 3 Site Controller System Manual Chapter 4 Installation
Intercabling Connections
213 RFC #6 combiner/multicoupler
amplifier
43 21
18 46
214 RFC #6 combiner/multicoupler
power supply
42 20
20 45
215 RFC #6 tower top amplifier 45 19
17 44
216 RFC #5 circuit breaker 40 18
15 43
217 RFC #5 combiner/multicoupler
amplifier
39 17
14 42
218 RFC #5 combiner/multicoupler
power supply
38 16
16 41
252 RFC #5 tower top amplifier 41 15
13 40
255 customer-defined output 26
2
1
256 customer-defined output 28
4
3
NOTE: Pinout connections in “Punch block 2 (left side)” column indicate pins where jumpering between punch block 2 left and
right sides is required. Install jumper from pin specified in “left side” column to the pin specified immediately to the right in
“right side” column. For example, on alarm code 217, jumper is to be installed from punch block left-side, pin 39 to punch
block right-side, pin 17.
Table 4-25 Punch block 2 (user alarm) pinouts — continued
Alarm
code
EAS/EAS2 function
Punch block 2
signal pairs (left side)
(NOTE)
Punch block 2
signal pairs (right side)

Motorola iDEN Site Controller Specifications

General

Brand	Motorola
Model	iDEN Site Controller
Category	Controller
Language	English