Motorola iDEN Site Controller - ACG# Help

68P80801E30-A 5/1/2002 6-9
Gen 3 Site Controller System Manual Chapter 6 System Testing
Site Controller Verification
ACG# help
Available commands:
• config -Change configuration parameters
• date -Read/Set system clock
• dbg -Set/Clear/Show debug flags
• dir -Show file directory
• exit -Exit configuration mode
• go -Execute application code
• help -Print this info
• iso -Configure ISO timeout
• load -Load file into memory via ethernet
• loadall -Load all files into memory via ethernet
• makeroom -Make room after a file
• mcd -Enable/Disable memory corruption detection
• nvr -Dump NVRAM
• packdfs -Pack existing files in DFS memory
• passwd -Change operator password
• probe -Enter pROBE debugger
• put -Send file via tftp to another host
• reset -Reboot this processor
• rm -Delete file(s)
• savedfs -Save DFS
• status -Print configuration parameters
• sum -Compute CRC on memory range
• ver -Print firmware version
• install -Run ACG Install code
• net -Configure for T1/E1
Online help
To list available site controller commands, type help.