68P80801E30-A 5/1/2002 6-29
Gen 3 Site Controller System Manual Chapter 6 System Testing
GPS Status
GPS Status
Use these procedures to verify the Global Positioning Satellite (GPS) status.
1. At the iSC> prompt, type: ping gps or display gps alarms
2. Verify the following information is displayed on the service
computer:
iSC> ping gps
GPS on line
Satellite Tracking Status site sync down
Frequency Lock Status not locked
Alarm status OK
iSC>display gps alarms
GPS Alarm StatusOK
Self-test OK
GPS Software version OK
GPS Communications OK
Online Fault OK
Idle-mode fault OK
GPS IPPS OK
HSO 1PPS OK
HSO locked to GPS UNKNOWN
Time/frequency output #1 OK
Time/frequency output #2 OK
Oscillator aging UNKNOWN
Total number of alarms 0
To Next Page
Loading...
