Motorola iDEN Site Controller - List of Figures

68P80801E30-A 5/1/2002
vii
Gen 3 Site Controller System Manual Front Matter
List of Figures
List of Figures
Figure 2-1 iDEN system diagram..................................................................................2-2
Figure 2-2 Inside the EBTS ...........................................................................................2-3
Figure 2-3 EBTS Control Cabinet................................................................................. 2-4
Figure 2-4 Site Controller Block Diagram.................................................................... 2-5
Figure 2-5 Site Controller front view ......................................................................... 2-7
Figure 2-6 Site Controller rear view ......................................................................... 2-8
Figure 4-1 Typical Cabinet layout ................................................................................4-4
Figure 4-2 Site Controller junction panel (rear view) .................................................. 4-8
Figure 4-3 5 MHZ/1 PPS Connections for Single RF Cabinet Omni Sites ................ 4-22
Figure 4-4 5 MHz/ 1PPS Connections for 2 RF Cabinet Omni Expansion Sites........4-22
Figure 4-5 5 MHz/1 PPS Connections for 3 RF Cabinet Omni Expansion Sites........4-22
Figure 4-6 5 MHz/ 1PPS Connections for Omni Sites Using More
Than 15 Channels.............................................................................. 4-23
Figure 4-7 5 MHz/1 PPS Connections for Sectored Sites ........................................... 4-23
Figure 4-8 5 MHz/1 PPS connections ......................................................................... 4-24
Figure 4-9 Ethernet Connections for Single RF Cabinet Omni Sites.......................... 4-27
Figure 4-10 Ethernet Connections for 2 RF Cabinet Omni Expansion Sites.............. 4-27
Figure 4-11 Ethernet Connections for Sites Using 3 or More RF Cabinets ............... 4-28
Figure 4-12 Ethernet Connections for Sectored Sites ................................................. 4-28
Figure 4-13 Alarm Connections for 800 MHz Duplexed RFDS
(0182020V06 and earlier) Sectored Sites ......................................... 4-34
Figure 4-14 Alarm Connections for GEN 4 RFDS / 900 MHz Duplexed RFDS Sites 4-35
Figure 4-15 Alarm Connections for Cavity Combining RFDS Omni Sites................. 4-36
Figure 4-16 Alarm Connections for Cavity Combining RFDS Sectored Sites............4-37
Figure 4-17 Alarm Connections (Systems with 4-8 RF Racks) ................................... 4-38
Figure 4-18 Alarm connections on the EAS/EAS2 ...................................................... 4-40
Figure 4-19 EAS/EAS2 to punch block 1 and punch block 2 connections .................. 4-41
Figure 4-20 EAS/EAS2 rear panel connectors............................................................4-42
Figure 4-21 Punch block jumpering examples............................................................4-51
Figure 4-22 Telco (T1/E1) interface with the system .................................................. 4-57
Figure 4-23 T1 interface cable configuration ............................................................. 4-58
Figure 5-1 Cabinet Breaker Panel for standard site controller rack or
SRRC (front view)................................................................................ 5-2
Figure 5-2 Power Supply Rack Breaker Panel (front view)..........................................5-3
Figure 5-3 Cabinet Breaker Panel (front view) ............................................................5-4
Figure 6-1 Pin-outs for the T1 test cable..................................................................... 6-17
Figure 6-2 T1 test connections .................................................................................... 6-18
Figure 6-3 Site Reference - 25% and 75% duty cycle pulse mask .............................. 6-32