Motorola iDEN Site Controller User Manual

Chapter 6 System Testing Gen 3 Site Controller System Manual
Site Controller Verification
6-6 68P80801E30-A 5/1/2002
Note: For ProComm users: The following versions are supported:
• ProComm Plus version 1.1b
• ProComm (all versions)
• ProComm Plus for Windows™ (all versions)
1. Start the service computer. For the appropriate startup procedure,
refer to the Service Computer Startup section in this chapter.
2. Power up Controller A.
3. After the self-test is complete on Controller A, verify that the
following messages appear on the service computer terminal:
4. Press any key within 10 seconds. When prompted, enter the proper
password and press return.
Note: The display does not reflect the entry of the password.
The default password is factory.
The ACG# prompt is displayed on the service computer once the
correct password has been entered.
Access Controller Gateway
Firmware Rev RXX.XX.XX (PowerPC)
Copyright (c) 2000
Motorola, Inc.
Unauthorized Access Prohibited
Current status:
Active/Standby Status: UNKNOWN
MAC Address: XX:XX:XX:XX:XX:XX
To enter configuration mode, hit any key within 10 seconds:

Motorola iDEN Site Controller Specifications

General

Brand	Motorola
Model	iDEN Site Controller
Category	Controller
Language	English