Chapter 8 Software Commands Gen 3 Site Controller System Manual
Site Controller Commands
8-12 68P80801E30-A 5/1/2002
Note: Quad BR must be switched to the test mode, by pressing the
diagnostic reset button located on the BR front panel, in order to
communicate with iSC. Refer to System Testing section in Volume 1
(System Installation and Testing) of EBTS manual for more
information.
CUSTOMER OUTPUT
Syntax:
customer output <activate/deactivate>
The 'customer output' command activates or deactivates the customer output.
Example:
MONITOR
Syntax:
monitor <off | gps | external | 5mhz>
The 'monitor' command selects the input source of the front panel monitor
port.
The user can monitor the following:
iSC> monitor off -- no signal (default)
iSC> monitor gps --GPS 1pps
iSC> monitor external -- External 1pps
iSC> monitor 5mhz -- 5MHz clock
SELFTEST
The 'selftest' command executes a series of hardware tests and reports results
to the user.
iSC> customer output activate
To Next Page
Loading...
