Chapter 1 Manual Overview Gen 3 Site Controller System Manual
Static Sensitive Precautions
1-8 68P80801E30-A 5/1/2002
■ Be sure to ground all electrically powered test equipment. Connect a
ground lead (-) from the test equipment to the board or module before
connecting the test probe (+). When testing is complete, remove the test
probe first, then remove the ground lead.
■ Place all circuit boards and modules on a conductive surface (such as a
sheet of aluminum foil) when removed from the system. The conductive
surface must be connected to ground through 100kΩ.
■ Never use non-conductive material for packaging modules for shipment or
storage. All modules should be wrapped with anti-static (conductive)
material. Replacement modules shipped from the factory are packaged in a
conductive material.
■ If possible, retain all original packing material for future use.
To Next Page
Loading...
Need help?
General
