44
Your MTH800 shows the Group name and the caller’s private
number or name if previously stored in your contact list.
The following screens show examples of how the caller’s
private number (ID 124) is displayed.
For incoming call alert, see settings in the Vibrate menu option
(page 114) and the Tones menu option (page 119).
Any incoming Group call is ALWAYS received through the main
speaker. If configured by your Service Provider, the Group
Audio menu item allows to setup the audio of the incoming
Group Call.
If the setup is Speaker Control, you can direct the audio of an
active group to the earpiece (low audio) or the main speaker
(high audio). In low audio speak into the bottom microphone
and listen via the earpiece. In high audio speak into the top
microphone and listen via the speaker.
At the end of a call which has been directed to the earpiece, an
audio hang timer is activated, if it is enabled by your Service
Provider. Within the preprogrammed hang time, any incoming
call is still received through the earpiece. When the timer
expires, a low pitch tone is emitted alerting you that the next
incoming Group call will be received through the speaker. Upon
hearing this alert, you are advised to hold the terminal at a
comfortable distance away from the speaker.
When receiving a Group call, you will hear a “New Group Call”
tone (if configured by your Service Provider).
Optns Folder
Group In Use
ID:124
TG4
Private ID
without alias
Private ID
with alias
OR
Group In Use
Folder 1
TG4
Optns Folder
To Next Page
Loading...
Need help?
General
