Motorola MTH800 User Manual

45
TMO Group Call
Receiving a Group Call in Idle Screen with Scan Off
You can receive a group call from the selected
talkgroup or from the associated ATG only.
Your MTH800 will receive the Group Call.
Receiving a Group Call in Idle Screen with
Scan On
With Scan On, you can receive a group call
from the scan list you set up, in addition to
receiving a group call from the selected
talkgroup or from the associated ATG.
Receiving the scan call functions as receiving
an associated ATG or selected call in scan off
(see previous page), except for the following:
• The display is different when receiving the call in idle
screen, as shown here.
• The terminal sounds a tone as explained in the note below.
• To block reception of a Group Call, select Optns then
Block. Powering off/on the terminal unblocks the reception
of this Group Call.
Receiving a Group Call during an On-going Group Call
Depending on how the Service Provider has configured
incoming calls, the incoming call will either be:
• Forced upon you and will interrupt the on-going call (if the
incoming call has higher priority than the on-going call).
OR
• When receiving a High Priority Group Call, you will hear a
“High Priority Group Call” tone (if configured by your Service
Provider).
• When receiving a Group Call from your scan list, which is not
from a high priority group, you will hear a “New Group Call”
tone (if configured by your Service Provider).
Group In Use
TG4
ID: David
Optns Folder
Group In Use
TG4
ID: David
Optns End

Motorola MTH800 Specifications

General

Frequency Range	380-430 MHz
Operating Temperature	-30°C to +60°C
Ingress Protection	IP54
RF Power Output	1W
Battery Type	Li-Ion
Channels	1000