54
3. The MTH800 will use the first available
repeater for that talkgroup. The repeater
icon will flash upon selecting that option.
When the MTH800 detects the proper
repeater presence signal, the Repeater
icon will turn solid.
Selecting DMO Group Call via Gateway and
Repeater
While in DMO, proceed as follows to choose the Gateway
and Repeater option to set up a call via Gateway or Repeater
(Gateway preferred) for the selected talkgroup.
1. Press Optns, scroll to Config and press Select.
2. Scroll to GW + Rep and press Select.
3. The display shows the last “GW + Rep.”
type selection. Use the navigation key to
scroll to your selection and press Select:
Automatic
— the MTH800 will use the first
available gateway for that talkgroup. The
Gateway icon and the Repeater icon will
flash upon selecting that option.
Specific
— the MTH800 will use only the gateway with the
specified gateway address for that talkgroup.
Upon selecting “Specific”, you will see one of the following
displays:
• The selected gateway address (e.g.:
1022), pre-programmed by your Service
Provider or previously entered by
yourself via the keypad. Press Edit and
then Ok to use the current address, or
press Edit and enter a new address via
the keypad, and press Ok.
DMO Folder 1
Police
Hello
Optns Contcs
DMO Folder 1
Police
Hello
Optns Contcs
GW Options:
Automatic
Specific
Select Back
Selected
Gateway:
1022
To Next Page
Loading...
Need help?
General
