Chapter 5 TelnetCE Configuration
Introduction
This chapter provides instructions required for connecting serial scanners in a Wavelink TelnetCE session via the
VC70 vehicle computer.
This chapter provides instructions on how to:
•
Connect LS3408-ER Corded Scanner to a Serial Port of the VC70 (SSI) on page 5-4
•
Connect DS3508-ER Corded Scanner to a Serial Port of the VC70 (SSI) on page 5-7
•
Connect LS3408-ER Corded Scanner to a Serial Port of the VC70 (Serial) on page 5-10
•
Connect LS3408-ER Corded Scanner to USB Port of the VC70 (Scan Handlers) on page 5-29
•
Connect DS3508-ER Corded Scanner to a Serial Port of the VC70 (Serial) on page 5-19
•
Connect DS3508-ER Serial Scanner to USB Port of the VC70 (Scan Handlers) on page 5-37
•
Connect LS3408-ER Scanner to USB Port of the VC70 (HID) on page 5-27
•
Connect DS3508-ER Scanner to USB Port of the VC70 (HID) on page 5-35
•
Connect a Bluetooth Scanner RS507 Directly to the VC70 (Scan Profile) on page 5-43
NOTE For Speakeasy on Wavelink TE refer to Symbol Technologies Support Center or Wavelink website.
NOTE Before starting Wavelink TE, make sure DataWedge application is not running to avoid software
conflicts.
NOTE For best performance, when using Wavelink TE, DataWedge application should not be running, unless it is
specifically planned for.
Once DataWedge is started, it will be running in the background. To make sure DataWedge is disabled
when Wavelink TE is running create a profile within DataWedge, associate the Wavelink TE to this profile,
then un-check the Enabled option for that profile. This will disable DataWedge when Wavelink TE is
running, but allow DataWedge to be used for other applications.
Refer to the Help file in the DW Toolkit available on the VC70 page on Support Central:
https://portal.motorolasolutions.com/Support/US-EN/Resolution?solutionId=88037
To Next Page
Loading...
Need help?
General
