NPort Server User’s Manual
D-2
Log on as a member of the Administrators group for the local computer to install
and configure TCP/ IP. Follow these steps to install network card on a Windows
NT computer:
1. Right click the Neighborhood on the desktop and click on Properties.
2. Choose Adapter then select Add. The system will show you a list of network
card. Follow your network card manual to choose the card type you have or
install from a disk and click OK to continue.
3. After the system installing the software for your card, Windows NT system
will prompt you a dialog box to configure the TCP/IP protocol if your NT
system already have TCP/IP driver installed. You may continue with the
section to configure TCP/IP.
. Note: The Windows NT 4.0 system asks you about installing some network
protocols while installing the system. If your system do not have the TCP/IP
protocol installed, you may follow the steps above and choose protocol to
add TCP/IP.
Configuring Your Windows NT with Dedicated IP Address
To configure your Windows NT to work properly with NPort Server, you should
give your computer a dedicated IP address without using DHCP.
1. Right click Network Neighborhood and select Properties.
2. Choose Protocol.
3. Choose TCP/IP then click on Properties.
4. Select the network card using for connecting NPort Server.
5. Choose configure IP address.
6. Enter your IP address and subnet mask as assigned by your LAN administrator.
7. Go to DNS dialog. Enter your DNS you get from your Network administrator.
You may just leave it blank if you don t have this address.
8. Go to Gateway dialog. Enter the router IP address to the gateway box if you
have a router.
To Next Page
Loading...
Need help?
General
