Setting Up Custom 5-17
Configuring Through View by IP
View by IP displays access control list on IP address base. It is clear to see what IP
address has been granted to what ports and what IP addresses are allowed onto the
server.
Adding Access Permission of One Host
If there is a host who is permitted to access to all ports on some specific server, it is
recommended that you configure through viewing by IP address.
1. Go to “Access Control” page. Select “IP address from the “View access control
list by”.
2. Click on the Server you like to modify.
3. Click on Add IP.
4. On the popped up screen for Grant Access IP, select a single computer if you
like to add access for one computer and enter the IP address of the host. If it is
for a group of computer, check on the box for a group of computers then enter
the IP address and netmask. For example, enter IP address 192.168.1.0 and
netmask 255.255.255.0 for network class C computer.
5. Click OK.
To Next Page
Loading...
Need help?
General
