NPort Server User’s Manual
2-10
1. Connect the power chord to NPort Server.
2. Connect the power male end of power chord to the power outlet.
3. On the rear panel of the NPort Server, turn ON the power by switch the I/O to
the I position.
4. Check the S0 LED on the front panel if that is on.
Connecting Asynchronous Serial Devices
You may use the RJ-45 to female DB25 cable enclosed in the package to connect to
your Serial Devices with male DB25 connector. Or, check with Appendix for detail
pinouts to make your own cable. You may use the RJ-45 to male DB25 cable enclosed
in the package to connect to the modem. Check with Appendix C for detail pinouts to
make your own cable.
P1
To Next Page
Loading...
