Setting Up Single-Host
3-13
Configuring Server Password
To add security to your NPort Server, it is highly recommended that you set a
password as soon as you complete installing the server. If you do not set the
password during Add Server Wizard or you would like to change current
password, you may enter into Server Properties to set a new password. The other
action for this Password page is to 'Auto-Save' your password to your Windows
NT. By auto saving the password, you will not be asked for the password checking
anymore.
Steps for configuring Server’ s Password:
1. Click on the Server you want to make changes.
2. Click on Server Properties from toolbar.
. Note: If you mark off Auto-Save of password, you will be asked to input the server
password. If you fail to input the password, you can only browse server
general information but you cannot make any modification.
3. Select page for Password.
4. Enter current password and the new password to make changes.
5. Check on Auto-Save box to save the password.
6. Save Configuration as needed.
To Next Page
Loading...
Need help?
General
