Setting Up Single-Host
3-1
3
3
Setting Up Single-Host
This chapter describes the steps for setting up NPort Server for single-host type of
application. Single-Host users apply the NPort Server to the traditional multiport
serial application.
In this chapter, you will find the following topics specified for Single-Host
Multiport Users:
q Driver and Software Installation
q Adding a NPort Server
q Configuration Using NPort Manager
Ø Saving Your Configuration
Ø Adding Other Server
Ø Deleting Server
Ø Modifying Mapping COM Names
Ø Unmapping Ports
Ø Configuring Server General Information
Ø Configuring Server Password
Ø Replacing A Server
q Upgrading NPort Server firmware
q Uninstalling the Software
To Next Page
Loading...
