MPI 40 Series - Page 81

Angled Area
A. Turn the upper set screw counter-clockwise two revolutions.
B. Close the door.
C. While continuously checking "play" in the pressure pad arm
turn the upper set screw clockwise until the "play" is gone.
I CAUTION I
Do not over tighten the presure pad
arm as damage to diskettes may occur.
D. On the pressure pad arm, turn the adjustment screw until the
head of the screw is just touching the head load solenoid
arm.
Ejector Release Spring-End
Ejector Spring
Ejector Block
Figure 4-14: Ejector Spring
4-28