MR ECOTAP VPD CONTROL PRO - Changing Password

8 Operation
Maschinenfabrik Reinhausen GmbH 2018 1475252433/02 EN ECOTAP
®
VPD
®
CONTROL PRO
Function Data display Diagnostics Operator Parameterizer Administrator
Configuring digital inputs and
outputs
- - - + +
Setting TPLE - - - + +
Configuring data points - - - + +
Calling up the maintenance
wizard
- - - + +
Changing tap position table - - - + +
Enabling ECOTAP Modbus - - - + +
Adding sensors to the MR
sensor bus
- - - + +
Table51: Access rights permanently linked to the roles
8.13.2 Changing password
All users can change their passwords provided that the user account is not
set up as a group account. You can only change a group account's pass-
word if you are logged in as the administrator.
Note that the password must satisfy the following requirements:
▪ At least 8 characters
▪ At least 3 of the 4 following character types
– Upper case letters
– Lower case letters
– Numbers
– Special characters
To change the password, proceed as follows:
1. Select the user name in the status line.
Figure94: Changing password