MR ECOTAP VPD CONTROL PRO - Mounting the Device on an Alternative Cap Rail

6 Mounting
Maschinenfabrik Reinhausen GmbH 2018 435252433/02 EN ECOTAP
®
VPD
®
CONTROL PRO
6. Plug the UI assembly plugs into the corresponding slots and engage
them.
Figure25: Engaging the plug
6.4.2 Mounting the device on an alternative cap rail
As an alternative, you can mount the device onto a cap rail other than that
included in delivery. When doing so, note the following instructions.
6.4.2.1 Removing assemblies
If you would like to mount the device on an alternative cap rail, you must re-
move the individual assemblies from the cap rail included in delivery. When
doing so, observe the schematic in the connection diagram included in deliv-
ery.
Figure26: Overview of assembly removal