MR ECOTAP VPD CONTROL PRO - Displaying Current Measured Values; Displaying Measured Value Recorder (Optional)

8 Operation
Maschinenfabrik Reinhausen GmbH 2018154 5252433/02 ENECOTAP
®
VPD
®
CONTROL PRO
You can change the measured value display to the generator sign conven-
tion by activating the Retrofit TAPCON® 2xx parameter.
8.15.1 Displaying current measured values
The current measured values can be displayed in the measured value
screen. The following measured values are displayed:
▪ Voltage
▪ Current
▪ Power factor (cos ϕ)
▪ Frequency
▪ Reactive power
▪ Active power
▪ Apparent power
Figure100: Measured values
To display the current measured values, proceed as follows:
► Go to Measured values.
8.15.2 Displaying measured value recorder (optional)
You can use the optional measured value recorder function to display the
progress of measured values and signals over time.
Depending on device configuration, you can select the following measured
values and signals for the display: