MR ECOTAP VPD CONTROL PRO - Information about Device; Hardware

8 Operation
Maschinenfabrik Reinhausen GmbH 2018166 5252433/02 ENECOTAP
®
VPD
®
CONTROL PRO
Figure104: Average value recorder
To set the average value interval, proceed as follows:
1. Go to Settings > Parameters > Recorder > Average value interval.
2. Set parameter.
3. Press the Accept button to save the modified parameter.
8.16 Information about device
In this menu, you can view information about the device.
8.16.1 Hardware
Under Hardware, you can display information about the device's hardware.
For the assemblies, you will find information about the signal level of the in-
dividual channels.
Figure105: Displaying information about the device's hardware