7.14.2 Engine oil – Change
Preconditions
☑ Engine is stopped and starting disabled.
☑ Engine is at operating temperature.
☑ MTU Fluids and Lubricants Specifications (A001061/..) are available.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
Engine oil
Sealing ring
(→ Spare Parts Catalog)
WARNING
Engine oil is hot.
Engine oil can contain combustion residues which are harmful to health.
Risk of injury and poisoning!
• Allow the engine to cool to below 50 °C before beginning work.
• Wear protective clothing, protective gloves, and safety glasses / facial protection.
• Avoid contact with skin.
• Do not inhale oil vapor.
Oil change without semirotary hand pump: Draining oil at drain plug on oil
pan
1. Provide a suitable container to collect the oil.
2. Remove drain plug and drain oil.
3. Install drain plug with new sealing ring.
4. Replace engine oil filter (→ Page 195).
Oil change with semirotary hand pump: Oil extraction
1. Provide a suitable container to collect the oil.
2. Extract all oil from oil pan using the semirotary hand pump.
3. Replace engine oil filter (→ Page 195).
Filling with new oil
1. Open cover on filler neck.
2. Pour oil in at filler neck up to "max." mark at
oil dipstick.
3. Close cover on filler neck.
4. Check engine oil level (→ Page 192).
5. After oil change and filter replacement, bar
engine with starting system (→ Page 147).
MS150031/06E 2016-010 | Lube Oil System, Lube Oil Circuit | 193
TIM-ID: 0000000031 - 007
To Next Page
Loading...
Need help?
General