3. Use oil filter wrench to unscrew cut-out oil fil-
ter.
4. Clean sealing surface on connecting piece.
5. Check condition of new oil filter sealing ring
and coat it with oil.
6. Fit SOLAS shield (→ Page 139).
7. Screw on and tighten new oil filter by hand.
8. Replace other oil filters in the same way.
9. Switch filter to normal position.
10. After each oil change and filter replacement,
crank engine with starting system
(→ Page 147).
11. Check oil level (→ Page 192).
Oil filter – Replacement with engine running
1. Reduce engine speed to <1100 rpm.
2. Use oil filter wrench to unscrew cut-out oil filter.
3. Clean sealing surface on connecting piece.
4. Check condition of new oil filter sealing ring and coat it with oil.
5. Fit SOLAS shield (→ Page 139).
6. Screw on and tighten new oil filter by hand.
7. Replace other oil filters in the same way.
8. Switch filter to normal position.
9. Check oil level (→ Page 192).
196 | Oil Filtration / Cooling | MS150031/06E 2016-010
TIM-ID: 0000006365 - 008
To Next Page
Loading...
