ii
Table of Contents
1.2 PACKAGE CONTENTS ·················································· 5
2. SAFETY INFORMATION ·················································· 6
2.1 Safety Symbols and Terms ·············································································· 6
2.1.1 Safety Symbols ····················································································· 6
2.1.2 Safety Terms ························································································· 6
2.2 General Safety Information ············································································ 6
3. GENERAL CHARACTERISTICS······································· 9
4. PERFORMING THE GENERAL INSPECTION ··················· 10
4.1 Performing the General Inspection ··································································10
4.1.1 Check whether there is any Damage on it Due to Transportation ····················10
4.1.2 Make a Check on Accessories ·································································10
4.1.3 Make a Check on the Complete Instrument ················································10
5. INPUT CONNECTIONS ·················································· 11
5.1 Input Connections ······················································································· 11
5.1.1 Input connections ···················································································· 11
5.1.2 The connection of 1 kHz/5 V Square-wave test signal ·········································12
5.2 Front Panel and Keys Overview ······································································12
6. USING THE OSCILLOSCOPE ········································ 15
6.1 About this Chapter ······················································································15
6.2 Powering Up the Oscilloscope ·········································································15
6.3 Oscilloscope Operation Window ······································································15
6.4 Menu Description ························································································17
6.5 Manually Setting the Vertical System, Horizontal System and Trigger Position ··········17
6.5.1 Setting the Vertical System ·········································································17
6.5.2 Setting the Horizontal System and Trigger Position ············································18
6.6 Recall factory settings ···················································································19
6.7 Input Connections ·······················································································20
6.8 Displaying an Unknown Signal with Auto Set ·····················································20
6.9 Automatic Zero-returning of Trigger Horizontal Position and Trigger Level Position ··21
6.10 Automatic Measurements ············································································21
6.11 Freezing the Screen ····················································································22
6.12 Using Average for Smoothing Waveforms ························································22
To Next Page
Loading...
