Description of Setup Buttons (Administrator Settings) 17-17
17
[Finisher Adjustment]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
Adjust the staple, punch or fold position.
Settings Description
[Center Staple Position] If the staple position is not on the fold line on saddle-stitched paper, use
this option to align the staple position on the fold.
For details, refer to page 17-18.
[Half-Fold Position] If the half-fold position is not on the exact center of the paper, use this op-
tion to align the fold on the center.
For details, refer to page 17-19.
[1st Tri-fold Position Ad-
justment]
If the tri-fold positions are not located evenly, use this option to adjust the
first fold position.
For details, refer to page 17-20.
[2nd Tri-fold Position Ad-
justment]
If the tri-fold positions are not located evenly, use this option to adjust the
second fold position.
For details, refer to page 17-21.
[Punch Horizontal Position
Adjustment]
If the positions of the punch holes on the paper are displaced sideways,
use this option to adjust the punch hole positions.
For details, refer to page 17-22.
[Punch Regist Loop Size
Adjustment]
If the positions of the punch holes on the paper are not in parallel with the
paper edge, use this option to correct the obliquity of the paper to make
them parallel.
For details, refer to page 17-23.
[Paper Alignment Plate
Settings]
If paper is not discharged with the edges aligned, use this option to adjust
the effective width of the paper alignment plate for making discharged pa-
per stored neatly.
For details, refer to page 17-23.
To Next Page
Loading...
Need help?
General
