The Control Lane displays the changes you recorded for each automated parameter.
To edit the modulation:
1. Click the desired parameter in the list of automated parameters (on the left) to select it.
2. Drag the modulation points vertically in the Control Lane.
For more information on editing modulation and automation, please refer to the Manual.
6.4 Saving Your Project
Again, it is recommended to regularly save your work. You can then open another Project or
close MASCHINE and take a break. Your tutorial Project will be recalled as it was the next time
you open it.
To save your Project in the software:
► Press [Ctrl] + [S] ([command] + [S] on macOS) to save your Project.
To save your Project on the controller:
► Press SHIFT + SAMPLING to save your Project.
6.5 To Sum Up…
In this tutorial, you have learned the following:
▪ The concept of Plug-in List (and Plug-in slot).
Applying Effects
Saving Your Project
MASCHINE MIKRO - Getting Started - 100
To Next Page
Loading...
Need help?
General
Weight and Dimensions
